4Runner 2010 - 2019 Installation Instruction

Please follow video below to remove your factory radio:

https://www.youtube.com/watch?v=b9IIVxsweEI

After removing factory radio, please remove air vent and hazard button from the factory radio. 

Put air vent and hazard button on the new radio. 

Connect the main harness to the vehicle side connectors. There will be extra connectors on both side not used. 

For backup camera, please locate the two male RCAs on the main harness. Depending on your vehicle's model year, one of the white plugs where the male RCAs are coming from is used. Connect that male RCA to a yellow female RCA with tag "Camera in". 

Then connect main harness, USB harness, RCA harnesses, SIM card tray, factory hazard harness and antennas to the back of the radio. 

The radio comes with SIM card/4G capability. After connecting the 4G antenna (the flat narrow antenna) and SIM card tray to the radio, put in the SIM card in the tray and lock the slid in. Turn on radio and hit "RST" hole with a pin to enable SIM card. 

Reverse the installation steps to put the radio back in. 

2010 - 2013 4runner camera and steering wheel control wiring:

Steering wheel control:

Radio side steering wheel control wires: 

Grey -> Key 1

Grey with black strip -> Key 2

Black wire -> Ground

Factory side:

SW1 to Key 1
SW2 to Key 2
SWG to ground(black wire) on our harenss.

After making connection, go to steering wheel study app to pair the functions.

OEM backup camera:

V+ -> male RCA +
V- -> male RCA -
CGND -> Ground (black wire)
CA+ ->Camera Power (6V)

After making connection, connect male RCA to a single female RCA on our unit, which is on a white connector at the back. The connector only has that female yellow RCA.

Or you can get this adapter:

AX-TOYCAM2-6V

https://axxessinterfaces.com/product/AX-TOYCAM2-6V

DO NOT use the following section unless you factory reset the unit: 

Connect the unit to wifi - go to setting - extra setting - 123456 - car choose - can box: SS or Simple Soft cars: Toyota, Models: 18 camry

If you accidentally reset the unit and the touch sensitive buttons on each side stopped working, use the video below to pair them. 

Car settings - General - extra setting - 123456 - ok - Touch Panel Key - Position - Left and Right - start - press top left box - choose function - press corresponding side key - repeat until all are paired - end

If your backup camera is showing distorted image like below, please change following setting:

For TS10

Apps - settings - Reverse on the left - then find "reversing system selection" - choose "NTSC"