LS 460 2010 - 2012 Hazard and Airbag Wiring

Hazard Wiring

***Only use this guide when hazard is not working after connecting the white plug in Pic 1. 

Cut orange with white strip wire from the white connector in the first picture. Then bridge the orange/white wire to the blue wire on vehicle's side. Follow second picture to locate the connector and the blue wire. 

Pic 1

Pic 2

Airbag Wiring

***Only use this wiring guide when hazard light is turned on and stayed on on dashboard. 

Please find this small heat shrink wrap piece on the main harness below. It is the airbag adapter. 

After locating the piece, note that there are three wires coming out of the connector, red, orange and purple. 

Cut only ORANGE and PURPLE wire at the spot marked above, leave at least 1 inch of wire on the adapter side. Leave RED wire connected. Follow the guide below to connect the orange and purple wires. 

1. If your factory radio comes with navigation, please use this guide:

Please locate L117 connector on the vehicle side. It is a 6pin blue connector. 

Please locate a RED wire behind pin 3 and a BLACK wire behind pin 4. Connect ORANGE wire to RED wire on the factory connector. Then connect PURPLE wire to BLACK wire. 

2.  If your factory radio does NOT come with navigation, please use this guide:

Please locate L35 connector on the vehicle side. It is a 26 pin white connector. 

Please locate a RED wire behind pin 9 and a BLACK wire behind pin 20. Connect ORANGE wire to RED wire on the factory connector. Then connect PURPLE wire to BLACK wire.