- 2016+ Cruze Installation Note

- Please make sure your Cruze does not come with factory amplifier. If it does then our radio will not work. 

After quick compatibility check, please follow the video below to remove your factory stereo:

https://www.youtube.com/watch?v=9ec1sGMEo9Q

After that, connect the brown and grey connector to the main harness of new stereo. Connect other matching connectors.

For factory backup camera, connect the male RCA from the main harness to Camera female yellow RCA. If you have no camera signal, please go to setting - install set - signal format - choose CVBS-AHD Signal

Route USB to desired spot then turn on the radio by turning on the vehicle to check functions. 

Make sure you have sound and AC controls. 

AC Settings:

Unit with proper climate control will have the control section at the bottom of the unit at all time. The bottom of the unit should not show bluetooth control. If you have seeing bluetooth control, please use the guide below to change the settings. 

If you do not have climate control, please check if climate control connector is connected.

Check if CANBUS decoder box is connected. 

Then on the unit, go to setting - install set/Advanced - 8861 - car type - choose Cruze 2017 Hi - make sure protocol is on BNR with AC - press Ok then press save and reboot. 

*Note if your factory has manual AC, please choose "Cruze 2017 Lo" in the car type settings. 

Both CAN Baudrate and Airbox Baudrate numbers are 38400.