- 2014 - 2020 Jeep Cherokee Installation Note

Please follow the video below to remove your factory radio:

https://www.youtube.com/watch?v=AUnkPG2Sg8E

or this one:

https://www.youtube.com/watch?v=FNN2yHRJR3U

After removing the factory screen, connect the provided harnesses to the factory connectors. 

There are couple rectangle connectors besides the main power connector: 

Black connector with RCA provides video input to the unit. Connect yellow male RCA from the main harness to female yellow RCA "Camera" on this connector to retain factory backup camera. 

Yellow connector: provides pre-amp output for aftermarket amp. [Optional]

Brown connector: USB connection for the radio. It can be connected to factory's mini USB so you can access that via USB ports in the vehicle. 

Remember to connect

Radio antenna adapter, a round metal connector; 

GPS antenna;

Wifi antenna. 

Then install the screen onto the radio and secure with screws. 

If the bezel comes separate, connect hazard connector to the bezel then put the bezel back on. 

Reverse the steps to connect factory AC back. 

The radio does not control AC. 

Sound Issue:

If the sound is low with statics, please go to "Console" on the top, swipe left or right if you do not see it - choose amp info - Cul Vol or volume - turn up the number. The problem should be fixed.