Please follow the video below to remove your factory radio:
https://www.youtube.com/watch?v=we5gI6DjVIc
After factory radio is removed, connect main harness to the two black connector used to connect to factory unit. The two connectors are one for power, speaker and data and the other one is for amp control if the vehicle comes with one.
Behind factory unit or CD player, there are two antenna connectors, one is radio and the other one is satellite. We will only use the radio connector.
The Molex plug mentioned in the video will connect to the back of the unit. That plug is for hazard control.
Behind factory screen, you will find either a 12 pin connector or a 54 pin large connector if you have a 8" screen. Connect them to their matching adapter. This connector is used to retain factory backup camera. There should be a yellow male RCA coming out from the adapter. Connect that to a yellow female RCA called "Camera" on a black rectangle plug. Then the plug goes to the back of the radio.
Yellow rectangle plug with RCAs are pre-amp output for aftermarket amp.
Brown rectangle plug with two USBs are the USB connections for the radio. If your factory has USB ports in the vehicle, you can use adapter to connect that to these two USB connector. Otherwise you can route the USB to the glove compartment or come out from center console.
*If your backup image is distorted or not showing, please check on both the adapter and black plug to see if any pin are bent.
Comments
0 comments
Please sign in to leave a comment.