2011 - 2015 Cruze Installation – Rhino Radios

Please disconnect battery before install to avoid shorting.

Please follow the video below to remove your factory radio:

https://www.youtube.com/watch?v=evZUHtYYvFE

After that, please connect all matching connections from the car side to the radio. Make sure the can bus decoder box is connected on the main harness. It is responsible for radio turn on.

Then please connect GPS and Wifi Antenna to the back of new radio. Reconnects vehicle battery.

Please test for audio before installing the radio back. Turn on vehicle > after screen turns on, go to the top and click on "Music" app > If music app is not seen, swipe left or right on the top > after music is playing, check if there is sound from the speaker. If not, please follow the guide below. If there is sound, please reverse the installation steps and install the radio back.

If Audio Does Not Work:

On your factory plug, locate this green wire, make sure it is the one right next to a thicker red wire:

Then splice this wire into that green wire.

After that there will be sound. The amp-c blue wire might be a bit short, we recommend using an extension.